Posts Tagged ‘vmware player’

How to Use the Missing Virtual Network Editor in VMware Player

March 13th, 2013 18 comments

For most people who use the VMware Player, DHCP is good enough for the NAT network. That means the IP addresses of your virtual machines may change after each powering on.

What if you want to have static IP addresses? It’s pretty easy as long as it’s in the same subnet. For example, if the VMnet8 has IP address of, your virtual machines should be configured in the same network say 192.168.47.x, where X can be any value from 3 to 254 (2 reserved for gateway, 255 broadcast by default).

Categories: Virtualization Tags: ,

Configure Static IP Address on Linux VM in VMware Player

March 12th, 2013 19 comments

If you run VMware Player, you would have 3 networking options for virtual machines running there: Bridged, NAT, Host-Only. In the latest 5.0.1, I also found a new one: LAN Segment. This blog has a nice explanation on these three settings if you want to get more details.

In most of cases, I use NAT for networking because the virtual machine can have Internet access which allows me to install additional software as needed. By default, VMware Player uses DHCP to dynamically assign IP address while using NAT. So you cannot guarantee to get same IP address after each rebooting.